Water Inlet/Drain Fault - Miele Dishwasher Operating Instructions Manual

Problem solving guide

Water inlet/drain fault

Problem
The dishwasher
stops working
shortly after the
start of the
programme.
The buzzer sounds.
The Inlet/Drain
indicator flashes
when the door is
opened.
The dishwasher
stops during a
programme.
The buzzer sounds.
The Inlet/Drain
check indicator
flashes when the
door is opened.
Fault code FXX
shows in the
display.
60
Possible cause
The stopcock is
closed.
Fault F12/F13:
Water intake is
restricted.
Fault F11:
Water outlet is
restricted, water
remains in the
wash cabinet at
the end of a
programme.
Remedy
– Open the stopcock fully.
Before rectifying the problem:
– Switch the dishwasher off using the
On/Off button K.
– Open the stopcock fully.
– Clean the water inlet filter (see
"Maintenance").
– The water pressure at the intake is
lower than 30 kPa (0.3 bar).
Seek professional advice.
– Clean the filter combination. See
"Cleaning and care".
– Clean the drain pump. See
"Maintenance".
– Clean the non-return valve. See
"Maintenance".
– Remove any kink in the drain hose.