Installing And Removing The Battery Pack; Operation; Mode Selection - DeWalt DC608-XE Instruction Manual

6. Do not freeze or immerse charger in water or any other liquid.
WARNING: Shock hazard. Don't allow any liquid to get inside charger. Electric
shock may result. To facilitate the cooling of the battery pack after use, avoid placing
the charger or battery pack in a warm environment such as in a metal shed, or an
uninsulated trailer.
CAUTION: Never attempt to open the battery pack for any reason. If the plastic
housing of the battery pack breaks or cracks, return to a service center for recycling.

Installing and Removing the Battery Pack

CAUTION: Engage contact trip lock-off before removing or installing battery.
FIG. 3
NOTE: Make sure your battery pack is fully charged.
To install the battery pack into the tool handle, align the base of the tool with the
notch inside the tool's handle and slide the battery pack firmly into the handle until
you hear the lock snap into place.
To remove the battery pack from the tool, press the release buttons (M) and firmly
pull the battery pack out of the tool handle.
TO INSTALL BATTERY PACK INTO CHARGER.
DANGER: Electrocution hazard. 230 volts are present at charging terminals. Do not
probe with conductive objects.
1. Plug the charger into an appropriate outlet before inserting battery pack.
FIG. 4
M
2. Insert the battery pack into the charger. The red (charging) light will blink
continuously indicating that the charging process has started.
3. The completion of charge will be indicated by the red light remaining on
continuously. The pack is fully charged and may be used at this time or left in the
charger.
COMPONENTS
WARNING: Lock off trigger, disconnect battery pack from tool and remove
fasteners from magazine before making adjustments or personal injury may result.
Refer to Figure 1 at the beginning of this manual for a complete list of components.

OPERATION

WARNING: Read the section titled Important Safety Instructions for Nailers at the
beginning of this manual. Always wear eye and ear protection when operating this
tool. Keep the nailer pointed away from yourself and others. For safe operation,
complete the following procedures and checks before each use of the nailer.
1. Wear proper eye, hearing and respiratory protection.
2. Remove battery pack from tool.
3. Lock the pusher in the back position and remove all fasteners from the magazine.
4. Check for smooth and proper operation of contact trip and pusher assemblies.
Do not use tool if either assembly is not functioning properly. NEVER use a tool
that has the contact trip restrained in the up position.
5. NEVER use a tool that has damaged parts.
WARNING: To reduce the risk of personal injury, disconnect battery pack from tool
before performing maintenance, clearing a jammed fastener, leaving work area,
moving tool to another location or handing the tool to another person.

MODE SELECTION

WARNING: ALWAYS wear proper eye [ANSI Z87.1 (CAN/CSA Z94.3)] and ANSI
S12.6 (S3.19) hearing protection when operating tool.
The D WALT cordless nailers are assembled in accordance with the ANSI Standard
E
SNT-101-2002.
10