Installation; Attaching The Sandpaper - Makita BO4551 Instruction Manual

INSTALLATION
CAUTION: Always be sure the tool
is
switched
off
and unplugged before
installing or removing the paper.
Attaching the Sandpaper
IMPORTANT: Use Makita hook-and-loop sandpaper with this sander.
To attach the sandpaper:
1.
2.
Set the tool upside down so that
the pad is on top.
Position the sandpaper to fit the
shape of the base. Be sure to
alian the holes on the SandDaper
with the holes on the pad (the
dust will be sucked into these
holes; it is therefore important to
leave them open).
Press the paper firmly over the pad.
3.
Removing the Sandpaper
To remove the sandpaper:
1. Set the tool upside down so that
the sandpaper is on top.
2. Grasping one corner of the
sandpaper, peel it from the pad.
Note: If the sandpaper is in good
condition, save it for future use.
Dust Bag
The use of the dust bag makes sanding
operations clean and dust collection
easy.
To attach dust bag:
1.
Fit the bag's entry port onto the
dust spout on the tool. Make
sure that the hole in the bag's
entry port is just over the pimple-
like protrusion on the dust spout.
Note: For the best results, empty the dust bag when it becomes approximately
half full, tapping it lightly to remove as much dust as possible.
4