Table of Contents
Advertisement
A
U
DVANCED
You will need the information in this section if you want to change the default settings that were set up by your
NSP or reprogram your remote control because it is not working correctly.
Your NSP programs your RG2400 and remote control when your system is first connected. The NSP also
Note:
programs the same Gateway ID (this is the ID of your RG2400) into all the remote controls in your home. If there
is more than one RG2400 in your home, your NSP programs the Gateway ID into each remote control that com-
municates with a specific RG2400.
C
P
HANGING OR
ROGRAMMING
By using the remote control, the RG2400 front-panel buttons, and on-screen menus, you can perform the follow-
ing tasks.
Determine the remote control Operating Mode
Set the remote control Operating Mode
Determine the Gateway ID
Set the Gateway ID
Determine the Remote Control ID
Set the Remote Control ID
D
ETERMINE THE REMOTE CONTROL
Press the LED key for three seconds until the LED flashes.
1.
Press the INFO key. The LED stops blinking at this point and stays on solid.
2.
Press and release the D key. When the D key is released, the LED immediately turns off.
3.
Watch the LED.
4.
The Operating Mode is indicated by a blink sequence. A short burst of flickering blinks indicates a '0' (SRC-
200 Compatibility Mode) while a single blink indicates a '1' (SRC-300A Native Mode.) There is a 1-second
pause before the LED turns on.
Once the LED sequence has completed, the SRC-300A returns to normal mode operation.
S
ET THE REMOTE CONTROL
The SRC-300A remote control operates older RG models as well as newer models. To allow for this, the remote
can be set to operate in either SRC-200 Compatibility Mode or SRC-300A Native Mode. When in SRC-200
Compatibility Mode, the SRC-300A transmits IR/UHF messages that use the same format as the SRC-200
remote control (messages are 16-bits in length.) When in SRC-300A Native Mode, the SRC-300A transmits IR/
UHF messages using the 18-bit message format. The default operating mode is SRC-200 Compatibility mode.
To program the operating mode:
Press and hold the LED key until it starts to blink.
1.
SE
S
ETTINGS
O
PERATING
O
PERATING
Program TV Code
Verify the TV RF channel
Set the Display Language
Set up Secondary Audio
Set the EADS (Emergency Alert Device Support) display
M
(SRC-300A
ODE
M
(SRC-300A
ODE
)
ONLY
)
ONLY
21
Advertisement
Table of Contents
