Starting And Stopping Your System; Starting Your System - HP Integrity rx2600 Getting Started Manual

Setting Up and Using Your System

starting and stopping your system

starting your system

1–10
HP Integrity rx2600 servers and workstation zx6000s come in many
different configurations. Pay careful attention to the directions below
and choose the options that match the OS and packaging you
purchased.
To start your system:
1. Turn on the monitor before you start your system.
2. Press the power button on the front panel. The system starts.
During system startup, the display may remain blank for up to
one minute. This is normal.
If the system has an MP card, the system light blinks.
If the system does not have an MP card, the following should
occur:
Power LED turns on
System LED blinks on and off
On workstation zx6000s with no MP card installed,
diagnostic LEDs 1-4 create scrolling pattern
3. If you are prompted for a password, type it and press
The prompt displays only if you have set a password using the
Extensible Firmware Interface (EFI). (See "Management
Processor" on page 1-25.)
HP Integrity rx2600 server and HP workstation zx6000 Getting Started Guide
.
Enter