Honeywell ScanPal 5100 User Manual page 25

Checking Battery Power
Power icons appear in the command bar at the bottom of the window. Select the battery icon to open the
Power Properties. The Battery tab opens displaying the charge status of both the main and backup
batteries.
Note: You can also check battery power by selecting Start -> Settings -> Control Panel -> Power.
Storage Guidelines
To maintain optimal battery performance, follow these storage guidelines:
• Avoid storing batteries outside the specified range of -4 to 122° F (-20 to 50°C) or in extremely high
humidity.
• For prolonged storage, do not keep batteries stored in a charger that is connected to a power source.
Guidelines for Battery Pack Use and Disposal
The following are general guidelines for the safe use and disposal of batteries:
• We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may pose a
personal hazard to the user.
• DO NOT attempt to charge damp/wet mobile computers or batteries. All components must be dry
before connecting to an external power source
• Replace defective batteries immediately; using a defective battery could damage the ScanPal terminal.
• Never throw a used battery in the trash. It contains heavy metals and should be recycled according to
local guidelines.
• Don't use a battery in any other manner outside its intended use in ScanPal 5100 terminals and
peripherals.
• Don't short-circuit a battery or throw it into a fire; it can explode and cause severe personal injury.
• Excessive discharge damages a battery. Recharge the battery when your terminal indicates low battery
power.
• If you observe that the Honeywell battery supplied is physically damaged in some way, send it to
Honeywell or an authorized service center for inspection. Refer to the
(page 11-1) section of this guide.
• Although your battery can be recharged many times, it will eventually be depleted. Replace it after the
battery is unable to hold an adequate charge.
• If you are not sure the battery or charger is working properly, send it to Honeywell or an authorized
service center for inspection.
.
Product Service and Repair
3 - 11