Honeywell Enviracaire Elite HE225A Owner's Manual page 6

HE225A,B AND HE265A,B BY-PASS FLOW-THROUGH HUMIDIFIERS
Every 1 to 3 Months
(Depending on Water Quality)
WARNING
Voltage Hazard.
Can cause electrical shock
and equipment damage.
Disconnect power and shut off water
supply before installing or servicing.
IMPORTANT
Never oil any part of the humidifier.
Use the following procedure to clean your
Enviracaire Elite™ Humidifier from Honey-
well:
1. Disconnect the power and turn off the
humidifier water supply.
2. Remove the humidifier cover.
3. Remove the humidifier pad assembly
from the humidifier by grasping the tray
and pulling it toward you.
4. Pull one side of the humidifier pad
assembly frame toward you and
remove the tray from the frame.
5. Gently pinch the water nozzle catches
inward until you can lift the water
nozzle off the tray.
6. Slide the humidifier pad out of the
frame.
7. Carefully scrape any mineral deposits
from the tray and frame. Be sure the
frame drain hole has nothing
blocking it.
69-1423EF–2
8. If excessive mineral deposits are
present on the humidifier pad, replace
with a new pad. For optimum perfor-
mance, Honeywell recommends
replacing the AgION™ antimicrobial
pad once a year.
9. Disconnect the drain hose from the
drain fitting on the bottom of the
humidifier housing.
10. Clean the drain fitting, if necessary.
11. Bend the drain hose to loosen any
mineral deposits.
12. Flush the drain hose with pressurized
water (a running tap) to clean the hose.
13. Reattach the drain hose to the
drain fitting.
14. Slide the humidifier pad back into
the frame.
15. Snap the water nozzle back onto the
tray.
16. Reattach the tray to the frame.
17. Place the humidifier pad assembly in
the humidifier housing and press until
the assembly is completely seated. Be
careful not to pinch or kink the water
feed tube.
18. Replace the humidifier cover.
19. Verify the humidifier operation by
following the steps in the Checking the
Humidifier for Proper Operation
section.
6