System Operation; To Arm The System And Leave - Honeywell OMNI-408 User Manual

System Operation

You can arm or disarm the burglar portion of your security system.
Before you can arm the system, it must be "ready." If you have a
protected door open, or if someone is moving in view of a motion
detector, the system will not display "READY."
The system is ready if the READY LED is lit and the display shows:
LCD Keypad:
SYSTEM READY
NOTE: If programmed by your installer, you may arm the system if a
delay or interior zone is faulted. However, faulted zones must be
restored before your exit time expires or an alarm or zone bypass will
result. Ask your installer if your system has this feature and, if so, if it
causes an alarm or zone bypass.

To Arm the System and Leave

Enter your User Code.
The ARMED LED goes on and the display shows:
LCD Keypad:
ON: AWAY
Exit through a door designated by your installer as an exit/entry door.
You must leave within the exit time programmed by your installer.
Refer to the reference sheet for the time that has been set for your
system.
– 10 –
Fixed-Word Keypad:
READY LED lit
Fixed-Word Keypad:
ARMED LED lit