Configure Output Port Settings - GE MultiSync 100 Instruction Manual

CONFIGURE I/O SETTINGS

Configure output port settings

30
1. Click the I/O tab in the GE Config window.
2. In the I/O Ports area, click to select P1 or P2.
3. In the IRIG-B / Pulse Output Port area, select an output time code from the drop-
down list:
– User defined pulse: user-configured time code.
– DCF-77 simulation: time code compliant with the DCF-77 specification.
– IRIG-B: time code compliant with the IRIG-B specification.
4. For a user-defined pulse, set the frequency, offset, and duration:
5. For a DCF-77 compliant time code, check the box to use UTC Time for the time code:
6. For an IRIG-B compliant time code:
Two different IRIG-B payload streams can be configured and used with different output
ports as needed.
CHAPTER 4: INTERFACES
MULTISYNC 100 GPS CLOCK – INSTRUCTION MANUAL