Related Documentation; Translated Safety Warnings - Cisco WS-X6066-SLB-APC Installation Note

To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to
Chapter 2, "Command-Line Interfaces," in the Catalyst 6500 Series Switch Cisco IOS Software
Configuration Guide.
To understand the Catalyst operating system command-line interface and Catalyst operating system
command modes, refer to Chapter 2, "Command-Line Interfaces," in the Catalyst 6500 Series Switch
Configuration Guide.
Unless your switch is located in a fully trusted environment, we recommend that you configure the
module through a Telnet connection using Secure Shell (SSH) encryption.
You can session into the module from the switch console to configure the CSM. The session is a Telnet
interface through the Ethernet out-of-band channel (EOBC) of the switch backplane.
You can also make a Telnet connection into the module from a specified host and on a specific interface.
Telnet support for this host should be configured or enabled from the module console.
Console output is redirected to all active Telnet sessions. When no Telnet session is available, the output
is saved to a buffer. The buffer output can be subsequently examined when you make a Telnet connection
into the module.

Related Documentation

Use this document with the following Cisco documents:
•
•
•
•
•
•

Translated Safety Warnings

Invisible laser radiation present. Statement 1016
Warning
Waarschuwing Onzichtbare laserstraling aanwezig.
Varoitus Näkymättömiä lasersäteitä.
Attention Rayonnement laser actif mais invisible.
Warnung Unsichtbare Laserstrahlung.
Avvertenza Radiazione laser invisibile.
78-15751-03
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide
Catalyst 6500 Series Switch Software Configuration Guide
Catalyst 6500 Series Switch Content Switching Module Command Reference Release 4.1
Catalyst 6500 Series Switch Content Switching Module Installation Guide Release 4.1
Catalyst 6500 Series Switch Content Switching Module and Installation and Configuration Guide
Release 4.1
Release Notes for the Catalyst 6500 Series Switch Content Switching Module Release 4.1.
Catalyst 6500 Series Switch Content Switching Module Installation Note
Related Documentation
21