Ctx2500 Card Specifications - Cisco CTX2500 Installation Manual

CTX2500 Card-Level Indicators
The CTX card has four card-level LEDs, described in
Table 1
Card-Level LEDs
FAIL LED (Red)
ACT/STBY LED
(Green/Amber)
SYNC LED
(Green/Amber)
CTX2500 Port-Level Indicators
Two bicolor LEDs show the status per port (Ports 1 and 2). The port LED is green if the port is available
to carry traffic and is provisioned as in-service. The port LED is red if there is a signal failure or loss of
signal on the port.

CTX2500 Card Specifications

Optical Ports
•
78-17333-01
CTX2500 Card-Level Indicators
Description
The red FAIL LED indicates that the card processor is not ready or that a
catastrophic software failure occurred on the card. As part of the boot
sequence, the FAIL LED turns on and flashes until the software deems the
card operational.
The ACT/STBY LED is green if the card is the active CTX2500 card. It is
amber if the card is the standby card.
The SYNC LED is green if the CTX2500 card detects both a primary and
secondary clock reference. It is amber if the card detects only a single clock
reference.
Line
Bit rate: OC-3 (155.520 Mbps), OC-12, (622.080 Mbps), and OC-48 (2488.320 Mbps),
–
depending on the SFP installed
Code: Scrambled NRZ
–
Fiber: Depends on the SFP used
–
(see the SFP specifications in the Cisco ONS 15310-CL and Cisco ONS 15310-MA Reference
Manual)
– Loopback modes: Terminal and facility
– Connectors: LC duplex connector for each SFP
Compliance: Telcordia SONET, Telcordia GR-253-CORE, ITU-T G.707, ITU-T G.957
–
Table 1.
Installing the CTX2500 Card in the Cisco ONS 15310-MA
CTX2500 Card Specifications
3