Honda 08A03-5E1-001 Installation Instructions Manual page 2

In-dash CD Changer (sold separately) :
P/N 08A06-3E1-300
In-dash CD changer
6 Washer-screws, 5 x 8 mm
Washer-screw, 4 x 6 mm
Wire tie
Harness clip
Seat
Owner's manual
2 of 13
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
10 mm Combination wrench
Ratchet
10 mm Socket
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers".
NOTE:
• The In-dash CD changer must be installed below
the audio unit.
• An additional bus cable is required when installing
multiple players.
• Two units of the player attachment kit are
necessary to install two units of the player.
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the meter panel (two self-tapping screws
and two clips).
All 30487-31491 (0511)
METER PANEL
SELF-TAPPING
SCREW
CLIPS(2)
©
2005 American Honda Motor Co., Inc. - All Rights Reserved.
5412041B