Driving; Driving The Rider; Braking; Stop The Engine - Husqvarna P 525D Operator's Manual

Driving the Rider

1 Release the parking brake before driving
2 Carefully press down one of the pedals until the required
speed is obtained. Pedal (1) is used to drive forwards, and
pedal (2) to drive backwards.
1
2
3 Lower the cutting unit by directly moving the lever forward
to the float position where the lever stays put.
4 Start the cutting unit if necessary by pulling up the switch
for the cutting unit.

Braking

Release the drive pedals. The machine slows and is stopped
by the drive system. Do not use the parking brake as the drive
brake.
Quicker braking is possible if you press down the drive pedal
for the opposite direction.

Stop the engine

Preferably allow the engine to idle for a minute to obtain
normal working temperature before stopping it if it has been
working hard.

DRIVING

Turn off the cutting unit using the PTO button.
1 Apply the parking brake by moving the handle downward.
2 Lift the cutting unit with the hydraulic lifting lever.
3 Move the throttle control to the MIN. position. Turn the
ignition key to "OFF"-position.
– 19
English