Driving The Machine - Husqvarna PT26 D Operator's Manual

• Connect the other end of the BLACK lead to a
good CHASSIS EARTH, away from the fuel tank
and battery.
Remove the leads in reverse order:
• The BLACK cable is removed from the chassis and
then the fully charged battery.
• Finally the RED cable from both batteries.

Driving the machine

1. Release the parking brake by pulling the handle
up.
2. Select high or low speed with the switch on the
control panel.
3. Carefully press down one of the pedals until the
required speed is attained.
Pedal (1) is pressed down to travel forwards and
pedal (2) to reverse.
4. Lower the cutting unit to the ground using the lifting
lever. Move the lifting lever forwards.
Parking brake
Speed selector
Driving pedals
Lifting lever lowering position
Driving
33