Table of Contents
Advertisement
Checking the Parking Brake
Visually check that no damage is found on
the neutral bail. Perform a test drive and
check that there is sufficent braking action.
To adjust the handbrake, contact the service
workshop if you are uncertain. Set the neutral
bail in the neutral lock position. Tighten the
wing nut. Check if the machine is braked, if
not tighten the wing nut again.
Checking the V-belts
Deck belt
Check every 100 hours of operation. Check
for severe cracking and large nicks.
NOTE: The belt will show some small cracks
in normal operation.
To replace belt lower the deck to its lowest
position. Remove the plate and belt shields.
Use a ratchet with a 9/16" socket on the
spring idler bolt to relieve the tension on the
belt. Slide the belt off of pulley and fully
remove the belt.
Reverse the proceedure for installation. See
the decal on the top of deck for belt routing
information.
After installation is complete check the belt
for twists.
MAINTENANCE
The neutral bail in locked position
Slackening the belt tensioner
8011-477
8011-775
41
English-
Advertisement
Table of Contents
