How To Change The Filters; If The Air Cleaner Does Not Operate; Storage - Honeywell 10200 Series Owner's Manual

How to Change the Filters...

CAUTION: DISCONNECT FROM POWER SUPPLY BEFORE SERVICING
The only two parts requiring any service are the activated
carbon pre-filter and the HEPA filter. No tools are needed.
To change either filter, disassemble the unit as shown.
1. Place the air cleaner onto its back
2. Press in the two tabs on the sides of the unit and lift off
the front grille (Fig. 1).
3. Remove the filter assembly (carbon pre-filter and HEPA
filter) (Fig. 2).
4. (A) To replace carbon pre-filter only:
Pull the carbon pre-filter apart from the HEPA filter (Fig.
3). Discard only the carbon pre-filter. Attach a new
carbon pre-filter to the HEPA filter.
4. (B) To replace carbon pre-filter and HEPA filter:
Discard both the carbon pre-filter and the HEPA filter.
Attach a new carbon pre-filter to a new HEPA filter.
5. Place the filters in the air cleaner (Fig. 4).
6. Replace the air intake grille. Press it into place until the
side tabs snap into their original position.
7. Turn the air cleaner into an upright position, plug into a
wall outlet and it is ready for operation.

If the Air Cleaner Does Not Operate...

• Check to make sure that the power cord is correctly connected to the outlet.
• Test that the outlet is functioning properly using another appliance or lamp.
• Check the fuse or circuit breaker. The outlet may be overloaded if other appliances are
also in use. Determine and correct the cause of the overload.
• If none of the above procedures restore operation, return your unit to the store or if the
store's return policy does not allow, return the complete unit per the instructions in the
warranty section of this owner's guide. Do not attempt to repair the unit yourself.

Storage...

If you store your Honeywell HEPA air cleaner for more than 30 days, we recommend:
• Remove both the primary HEPA filter and the activated carbon pre-filter from the unit.
• Discard the pre-filter.
• Wrap the HEPA filter in an air-tight plastic bag or plastic wrap. Be sure that the
filter is totally sealed.
• To restore the air cleaner to service, unwrap the HEPA filter, install a new
activated carbon pre-filter, and replace both filters in the air cleaner. See "How to
Change the Filters..." section for proper installation.
Fig. 1
Fig. 2
Fig. 3
Fig. 4