Replacing The Card Reader - Lenovo ThinkStation S30 Hardware Maintenance Manual

• To complete the installation or replacement, go to "Completing the parts replacement" on page 117.

Replacing the card reader

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important Safety
Information" on page 1.
This section provides instructions on how to replace the card reader.
Note: The card reader is only available in some models.
To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 83.
4. Locate the card reader. See "Locating FRUs and CRUs" on page 75.
5. Disconnect the card reader cable from the front USB connector on the system board. See "Locating
parts on the system board" on page 78.
6. Press the blue retaining clip to remove the card reader out of the chassis.
Figure 20. Removing the card reader
92
ThinkStation S30 Hardware Maintenance Manual