6. If you are replacing the hard disk drive enablement module, press the two tabs of the plastic standoff
toward each other and then lift the hard disk drive enablement module upward to remove it from the
system board.
Figure 34. Removing the hard disk drive enablement module
7. To install a new hard disk drive enablement module, align the hole in the module with the plastic standoff
on the system board and then position the module on the corresponding connector on the system
board. Press the hard disk drive enablement module downward until it is secured in place.
Figure 35. Installing a new hard disk drive enablement module
.
Chapter 10
Replacing FRUs
103