Listen To Radio; Store Dab Radio Stations Automatically; Basic Operations - Philips DTB3185 User Manual

6 Listen to radio

Note
•
For optimal reception, fully extend the antenna and
adjust its position, or connect an outdoor antenna.
•
This product does not support MW (medium wave)
radio reception.
•
You can program a maximum of 30 DAB radio stations
and 20 FM radio stations.
•
Check with local retailer or go to www.WorldDAB.org
for the applicable DAB radio frequencies in your area.
•
Refer to "Product information" > "RDS program types"
for more information about RDS radio stations.
Store DAB radio stations
automatically
If no DAB radio station is stored, this product
can search and store DAB radio stations
automatically.
1
Press CD/FM/DAB+ repeatedly to switch
to the DAB mode.
» [FULL SCAN] (full scan) is displayed.
2
on the main unit or OK on
Press
the remote control to start the auto
installation.
» This product automatically stores radio
stations with sufficient signal strength.
» After all available radio stations are
stored, the first stored radio station is
broadcast automatically.

Basic operations

Follow the instructions below for more
functions.
Tune to the next FM radio station with
sufficient signal strength at the lower/higher
frequency:
Press and hold /
search.
Tune to the FM radio station at a specific
frequency:
/ repeatedly until the
Press
frequency digitals are displayed.
Program FM radio stations automatically:
Press and hold PROG to start auto
programming.
Program DAB radio stations automatically:
Press and hold PROG to start auto scanning
and programming.
Program radio stations manually:
1) Tune to a radio station.
2) Press PROG to activate programming.
3) Press PRESET/ALBUM
sequence number to the radio station.
4) Press PROG to confirm.
5) Repeat steps 1-4 to program more radio
stations.
Tune to a preset radio station:
Press PRESET/ALBUM
Switch the audio mode between [STEREO]
(stereo) and [MONO] (monophonic) for FM
radio:
Press OK repeatedly.
Display available information about the
current radio station:
Press RDS/DISPLAY repeatedly.
Synchronize the clock with an RDS radio
station:
1) Tune to an RDS radio station that transmits
time signals.
2) Press RDS/DISPLAY to show the RDS time.
2) Press and hold RDS/DISPLAY until [CT
SYNC] is displayed.
to start the auto
/ to assign a
/ repeatedly.
EN 17