Cabinet Disassembly Instructions - AEG VCR 4500 Service Manual

CABINET DISASSEMBLY INSTRUCTIONS

1. Disassembly Flowchart
This flowchart indicates the disassembly steps to gain
access to item(s) to be serviced. When reassembling,
follow the steps in reverse order. Bend, route, and
dress the cables as they were originally.
[1] Top Case
[2] Front Assembly
[3] VCR Chassis Unit
[4] Jack CBA
[5] Deck Assembly
[6] Main CBA
[7] Cylinder Shield
[8] Jack Board [ VCR 4500 ]
2. Disassembly Method
ID/
LOC PART
Fig.
.No.
No.
[1] Top Case D1
Front
[2] D2
Assembly
VCR Chassis D3-1
[3]
Unit D3-2
[4] Jack CBA D4
Deck D5
[5]
Assembly D6
[6] Main CBA D5
Cylinder
[7] D5
Shield
Jack Board
[8] D5
[ VCR 4500 ]
↓ ↓ ↓
(1) (2) (3)
REMOVAL
REMOVE/*UNHOOK/
UNLOCK/RELEASE/
UNPLUG/DESOLDER
7(S-1)
*3(L-1),*4(L-2)
5(S-2), (S-4)
2(S-3) --- [ VCR 4505 ],
3(S-3) --- [ VCR 4500 ]
Desolder, (S-5)
2(S-6), Desolder
*(L-3) --- [ VCR 4500 ]
(S-7)
----------
↓
(4)
(1): Identification (location) No. of parts in the figures
(2): Name of the part
(3): Figure Number for reference
(4): Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P=Spring, L=Locking Tab, S=Screw,
CN=Connector
*=Unhook, Unlock, Release, Unplug, or Desolder
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
(5): Refer to "Reference Notes."
Reference Notes
CAUTION: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1. Remove five Screws (S-2), two Screws (S-3) and
Screw (S-4). Then, slowly lift the VCR Chassis Unit
(Deck Assembly, Jack CBA and Main CBA) up.
2. When reassembling, solder wire jumpers as shown
in Fig. D5.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on Main CBA as shown in
Fig. D6. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D6.
Note
-
(S-1)
-
1
-
[1] Top Case
2,3
-
-
-
↓
(5)
1-5-1
(S-1)
(S-1)
Fig. D1
HG462DC