Programming Thermostat; Initial Powerup; Factory Set Programming - Honeywell CHRONOTHERM T4700 Owner's Manual

Programming Thermostat

Initial Powerup

When the thermostat is first powered up (or
after eight hours of continuous power loss),
the display blinks for two seconds and then
undergoes a self-test — while 00E displays
for about 15 seconds.
This is followed by the display flashing
(1:00 PM); the internal checkout is
complete and the thermostat is ready to be
programmed.
To verify that the thermostat is turning on
the baseboard heater, press the (+) key
until the setpoint displayed exceeds the
room temperature.
The (°) symbol is flashing. Feel for warmth
in the area close to the heating element;
the unit should be starting to generate heat.
Press and hold the Prog key to return the
thermostat to the Run mode.

Factory Set Programming

The thermostat defaults to a normal non-
programmable thermostat at power-up,
indicated with Hold appearing in the
display. Pressing the Prog key once enters
the programming mode. The thermostat is
preset with a factory set schedule for 7
days, see Table 1.
Table 1. Preset Factory Schedule
Event
WAKE
LEAVE
RETURN
SLEEP
5
for 7-days.
Time Temperature
6:00 AM 70°F (21°C)
8:00 AM 61°F (16°C)
6:00 PM 70°F (21°C)
10:00 PM 61°F (16°C)
69-1396—2