Honeywell Modutrol IV Motors Series 90 Product Data page 6

SERIES 90 MODUTROL IV™ MOTORS
Adapter Bracket
The 220738A Adapter Bracket, positioned between the motor
and the equipment, raises motor shaft height by 0.75 in.
(19 mm) to match that of the former Modutrol
The following applications require this bracket:
• Q607 External Auxiliary Switch.
• Damper linkage applications require added clearance to
allow:
• crank arm rotation through the downward position.
• sufficient damper linkage to reach the motor shaft.
• All valve linkages except the Q5001.
NOTE: When no bracket is used in replacement applications,
damper linkages require adjustment for the new shaft
position.
To mount the motor with the bracket (see Fig. 3):
1. Mount the bracket to the equipment with existing or
standard bolts.
2. Using the provided bolts, mount the motor to the bracket
threaded holes.
For valve linkage applications (other than the Q5001):
1. Mount the bracket to the linkage.
2. Position the motor on the bracket to align the motor
shaft with the linkage.
3. Attach the motor to the bracket with the four bolts
provided. See Fig. 4.
VERTICAL
REFERENCE
FULLY
CLOSED
10
90
FULLY
OPEN
90 DEGREE STROKE
25, 35,60, AND 75 lb-in. TORQUE
VERTICAL
REFERENCE
FULLY
CLOSED
FULLY
OPEN
90 DEGREE STROKE
150 AND 300 lb-in. TORQUE
Fig. 2. Motor shaft positions at stroke limits
(viewed from power end of motor).
63-2190—3
®
Motor.
VERTICAL
REFERENCE
FULLY
CLOSED
10
160
FULLY
OPEN
160 DEGREE STROKE
M17090
6
Damper Linkages
The motor does not include a crank arm. Order the crank arm,
included in the Q605 Linkage, separately (see Accessories in
the Specifications section). For detailed instructions on the
assembly of specific linkages, refer to the instruction sheet
packed with the linkage.
CAUTION
Equipment Damage Hazard.
Stalling a motor can damage the drive shaft.
Ensure installation of motors and linkages allows the
motor to drive through full stroke without obstruction.
Valve Linkages
The Q100 Linkage requires the 220738A Adapter Bracket for all
valve applications. Applications with the Q5001 Valve Linkage
do not require the 220738A Adapter Bracket (see Fig. 4).
Junction Box
When used with liquid-tight conduit connectors, the junction
box provides NEMA 3 weather protection for the motor. The
junction box, standard with replacement motors, encloses the
terminals and provides knockouts for wiring conduits. Housing
an internal transformer or internal auxiliary switches requires
use of the junction box.
Wiring
CAUTION
Electrical Shock or Equipment Damage Hazard.
Can shock individuals or short equipment
circuitry.
Disconnect power supply before installation.
IMPORTANT
All wiring must agree with applicable codes,
ordinances and regulations.
1. Ensure that the voltage and frequency stamped on the
motor correspond to the power supply characteristics.
2. When connecting several motors in parallel, ensure that
the power supply VA rating is large enough to provide
power to all motors used without overloading.
3. Fig. 5 shows that the motor terminals are
quick-connects located on top of the printed circuit
board.
4. To access the wiring compartment:
a. Remove the four screws from the junction box top.
b. Lift off the cover.
5. Refer to Fig. 6 for typical wiring, and Fig. 8 for internal
auxiliary switch connections.
NOTE: Reverse motor rotation by switching wires at either
the motor or the panel. Reverse rotation on the
Series 90 models by reversing the wires at terminals
W and B.