Installation - Honeywell HCC-745NTW/PTW Operation Manual

3. Installation

3.1 The packing box should include, in addition to this User Guide:
-. One HCC-745NTW or HCC-745PTW camera
-. One 6-pin connection cable ( G-113510-200 )
-. One Auto Iris lens plug
3.2 Mounting a Lens
3.2.1 C/CS Mount Lens
① Remove the protective cap in front of the camera.
② Adjust the mount ring whether it is for C or CS.
③ Loosen Set Screw.
④ Turn the mount ring counterclockwise in case of C-Mount Lens.
Turn the mount ring clockwise in case of CS-Mount Lens
3.2.2 Auto Iris Lens
① Remove the cover of the auto iris lens plug and connect with the lens cable.
② Connect the auto iris lens plug to the 4-pin lens terminal on the side of
the camera.
③ Set the EE MODE to ALC MODE on the OSD menu ( see 5.6 AE MODE)
-. Auto iris lens with no amplifier : Set the DC LENS on the OSD menu
-. Auto iris lens with amplifier : Set the VSD LENS on OSD menu
☞ Adjust by using "LENS ADJ." on OSD menu to avoid hunting.
VSD LENS PIN CONFIGURATION
3 4
1 2
1. POWER(12V)
3. VIDEO SIGNAL
Set the select switch to VSD
DC IRIS LENS PIN CONFIGURATION
3
①③
② ④
1
2. NO CONNECTION
1. CONTROL-
4. GND
3. DRIVE+
- 8 -
4
①③
② ④
2
2. CONTROL+
4. DRIVE-
Set the select switch to DC