NETGEAR JNR1010v2 N150 User Manual page 47

Note: If you change the LAN IP address of the router while connected
through the browser, you are disconnected. If this situation occurs,
you must open a new connection to the new IP address and log in
again.
To change the LAN settings:

1. Log in to the router.
For more information, see
2. Select ADVANCED > Setup > LAN Setup.
The following screen displays:
3. Enter the following settings:
• IP Address. The LAN IP address of the router (by default, 192.168.1.1).
• IP Subnet Mask. The LAN subnet mask of the router (by default, 255.255.255.0).
Combined with the IP address, the IP subnet mask allows a device to know which
other addresses are local to it, and which must be reached through a gateway or
router.
• RIP Direction. Router Information Protocol (RIP) enables a router to exchange
routing information with other routers. This setting controls how the router sends and
JNR1010v2 N150 Wireless Router
Log In to Your Router After Installation
genie ADVANCED Home
47
on page 18.