Panasonic RS-485 Configuration

Unitized dome camera

Hide thumbs Also See for RS-485:

Page 1 Panasonic Unitized Dome Camera RS-485 Configuration Configure the DVR • Configure DIP Switches...
Page 2 Configure DVR Programming - 1 • In the Advanced programming menu, under COMM, Camera Control: • Change the type to RS485 for any cameras to be controlled via RS-485 Configure DVR Programming - 2 • In the Advanced programming menu, under COMM, RS485:...
Page 3 Configure DVR Programming - 3 • In the Advanced programming menu, under COMM, RS485, Control Camera Channel: • Set the cameras to the correct RS485 ports Rear of DVR Cabling • DVR Side Camera Side • Transmit A goes to Receive A •...
Page 4 Cabling Re-Cap Configure the Camera - 1 • Remove the camera from the mounting base to access DIP Switches.
Page 5: Configure Dip Switch 2
Configure the Camera - 2 • Configure DIP Switch 2: – Set Duplex – Set Termination Configure the Camera - 3 • Configure DIP Switch 1 for the correct Baud rate • Power the camera on and wait until the self-check routine finishes.
Page 6 Configure the Camera - 4 • Re-configure DIP Switch 1 for the correct unit number. See the manual for DIP switch settings. • Power the camera on and wait until the self-check routine finishes. • Note: If using Pelco-P protocol, Switch 6 &...
Page 7 AD Protocol Pelco-P Protocol...