Honda CD Changer Installation Instructions Manual page 9

38. Cut one piece of EPT sealer in half. Attach the
halves to the rear clip nuts you installed in step
36.
EPT SEALER
(Cut in half.)
REAR BASE
BRACKET
6 x 16 mm
WASHER-BOLT
39. Position the rear base bracket on the clip nuts,
and install two 6 x 16 mm washer-bolts. Tighten
the bolts securely.
40. Position the front base bracket on the clip nuts
and install two 6 x 16 mm washer-bolts. Tighten
the bolts securely. Attach one EPT sealer over
the head of the lower bracket bolt.
41. Push the clip of the vehicle wire harness
removed in step 35 into the hole in the rear base
bracket.
REAR BASE
BRACKET
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
EPT SEALER
FRONT
EPT
BASE
BRACKET SEALER
6 x 16 mm
WASHER-BOLT
VEHICLE
HARNESS
CLIP
42. Position the CD changer on the studs extending
from the front and rear base brackets, and install
the four flange nuts. Install the CD changer first
on the front bracket, then the rear bracket.
REAR
BRACKET
STUDS
43. Reinstall the relay that was removed in step 20.
44. Plug the BUS cable connector into the CD
changer.
BUS
CABLE
CD CHANGER CONNECTOR
AII 23268 (0110)
CD CHANGER
BOLT (reused)
VEHICLE RELAY
FRONT
BRACKET
STUDS
FLANGE
NUTS
9 of 10