Honda CD Changer Installation Instructions Manual page 4

9. Remove the four expansion clips that fasten the
floor carpet, and fold the carpet down and out of
the way.
Routing the BUS Cable
10. Route one end of the BUS cable up under the
dashboard, and out the radio opening. Position the
BUS cable connector alongside the radio
connector; then secure the BUS cable and the
vehicle harness with two short wire ties in the
areas shown.
(Position the BUS cable
connector flush with
the radio connector.)
11. Attach a piece of EPT sealer to the dash support
to protect the BUS cable.
4 of 10
EXPANSION
CLIP
FLOOR
CARPET
(Fold down.)
EPT SEALER
SHORT
WIRE TIES
RADIO
CONNECTOR
12. Route the BUS cable above the steering shaft,
and secure it to the vehicle harness with four
short wire ties in the areas shown.
SHORT
WIRE TIES
VEHICLE
HARNESS
HOOD
OPENER
13. Route the BUS cable down alongside the fuse
box, and secure it to the body panel with one
cushion tape. Secure the BUS cable to the vehicle
harness with the two short wire ties.
CUSHION
TAPE
AII 23268 (0110)
BUS
CABLE
FUSE
BOX
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
STEERING
SHAFT
FUSE BOX
SHORT
WIRE TIES