Propeller - Honda BF45A Owner's Manual

10. MAINTENANCE
Propeller
COTTER PIN
Mainless)
I
CASTLE NUT
PLAIN WASHER
SPECIAL SPLINE WASHER
PROPELLER
I
THRUST W'hER
MARINE GREASE
-asiih
If the propeller is damaged, replace it
as follows:
Removal:
Remove the c:otter pin then remove the
16
mm castle nut, 17 mm plain
washer, 10 mm special spline washer,
propeller and thrust washer.
COTTER PIN (stainless)
Installation:
Install the thrust washer with the
grooved side toward the gear case, then
install the new propeller in the reverse
sequence of removal.
Hand tighten the castle nut until the 4
mm cotter pin can be installed. If
necessary, tighten the castle nut just
enough to align the hole with the groove
in the nut.
Use a new genuine Honda cotter pin
and bend the cotter pin ends as shown.
90