Honda Security System Operating Instructions Manual page 21

Remote Control Code Programming (Only vehicles without Power Door Locks)
13
12
© 2004 American Honda Motor Co., Inc. - All Rights Reserved.
12
or
13
Press the "LOCK" or "UNLOCK" button
on the remote control transmitter.
• The status LED illuminates
simultaneously for 1 second to
indicate programming mode.
• To terminate the programming mode
at this point, either turn the ignition
key to the "OFF" position or leave the
remote's button untouched for over 10
seconds. To program the remote,
perform steps 2 through 12.
Press the "LOCK" button of each remote
(one at a line) to be stored in memory.
• The Status LED illuminates
simultaneously for 1 second to
confirm each entry.
• A button on each remote control
transmitter to be programmed must be
pressed. Perform the programming
step within 10 seconds for each
remote or else the programming mode
will terminate.
NOTE:
Only 3 remotes can be stored in the
system's memory.
21