4.5.3
Viewing Hard Disk Information
The [Controller View] window displays details of hard disks connected to channels of the controller.
Each drive column indicates the hard disks connected to one controller channel each.
Double-clicking a hard disk icon enables you to display the information of a specific hard disk.
The following information is displayed.
• Hard disk channel and target ID
These information is displayed on the title bar.
• Vendor
Hard disk vendor.
• Product
Hard disk part number.
• Revision
Version of firmware on the hard disk.
• Bus Width
SCSI bus width.
• ANSI Version
ANSI version supported.
• Nego. Transfer Speed / Nego. Bus Width
Current transfer speed (MB/second) and current transfer bus width.
The transfer speed may be below 320MB/sec if an error temporarily occurs in the
hard disk. Normally, if the status of the hard disk is not dead, this phenomenon
does not pose any problem to operation. However, if the performance is very low,
the transfer speed is reconfigured by restarting the system.
• Physical Capacity
Physical capacity of the hard disk.
Chapter 4 How to Use GAM
43