Restrictions For Iwag Scalability - Cisco Intelligent Wireless Access Gateway Configuration Manual

Restrictions for iWAG Scalability

Other hardware variants are not supported for SP WiFi applications. For more information, see
Note
for iWAG Scalability, page 3
The scale numbers provided in the table below assumes the following reference configuration:
• Walk-by users: A maximum of three traffic classes on the default session.
• Authenticated users: There are no traffic classes for authenticated users.
Any deviation from the conditions mentioned above may result in different scale numbers. The scale limits
and the hardware combinations listed in the next table requires 16GB of DRAM on ASR1000 Route Processor
2 (RP2).
Table 15: iWAG Scale: Maximum Number of IP Sessions Supported on ASR 1000 Hardware
Chassis
1001
1002-X
1004, 1006,
1013
1006, 1013
Restrictions for iWAG Scalability
The following are the restrictions pertaining to iWAG scalability:
The Intelligent Wireless Access Gateway (iWAG) feature is not supported on the following hardware.
• RP1 with ESP10 or ESP20
• ASR1002
• ASR1002F
Intelligent Wireless Access Gateway Configuration Guide
132
RP ESP
Integrated + 16 ESP-2.5G or
GB ESP-5G
Integrated + 16 ESP licensing
GB from 5G, 10G,
20, or 36G
RP2 + 16 GB ESP-40G
RP2 + 16 GB ESP-100G
iWAG Scalability and Performance
Walk-by Users Authenticated
Users
16000 8000
128000 32000
192000 64000
256000 128000
Restrictions
Total number of
Session
(combined
Authenticated
and Walk-by
Users)
24000
160000
256000
384000
OL-30226-03