48-Port 10/100Base-T Ethernet Switching Module (Ws-X6148-Rj45V); 24-Port 100Base-Fx Ethernet Switching Module (Ws-X6224-100Fx-Mt) - Cisco 7600 Series Module Manual

10/100 and 10/100/1000 Ethernet Switching Modules

48-Port 10/100BASE-T Ethernet Switching Module (WS-X6148-RJ45V)

The 48-port 10/100BASE-T switching module (WS-X6148-RJ45V) provides 48 switched, 10/100-Mbps
autosensing, full- or half-duplex ports. (See
with either Category 3, Category 5, Category 5e, or Category 6 UTP cable. The "V" in the product
number indicates that the inline-power daughter card (WS-F6K-VPWR) is installed on the module. With
the WS-F6K-VPWR daughter card installed, the module provides these IP phone features on each port:
•
•
•
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
Figure 2-5
The front panel LEDs are described in

24-Port 100BASE-FX Ethernet Switching Module (WS-X6224-100FX-MT)

The 24-port 100BASE-FX Etherent switching module (WS-X6224-100FX-MT) provides 24 switched,
100-Mbps, full or half-duplex ports. (See
connection to MMF optical cable.
This module is a Class 1 laser product. Refer to the Regulatory Compliance and Safety Information for
Note
the Cisco 7600 Series Routers for information on working with lasers.
The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.
Figure 2-6
The front panel LEDs are described in
Cisco 7600 Series Router Module Guide
2-20
Inline power—Provides 48 VDC over standard Category 5, Category 5e, or Category 6 UTP cable
up to 328 feet (100 meters) from the switch to the IP phone. With inline power, pairs 2 and 3 (pins
1, 2, 3, and 6) of the four pairs in the cable are used to transmit power (6.3 W) from the switch. This
method of supplying power is sometimes called phantom power because the power signals travel
over the same two pairs used to transmit Ethernet signals. The power signals are completely
transparent to the Ethernet signals and do not interfere with their operation.
Phone discovery—Automatically detects the presence of an IP phone and supplies inline power to
the phone.
Auxiliary VLANs—Provides automatic VLAN configuration for IP phones using IEEE 802.1Q as
the standards-based VLAN tagging mechanism between the switch and the IP phone.

48-Port 10/100BASE-T Ethernet Switching Module (WS-X6148-RJ45V)

WS-X6348-RJ-45V
STATUS

24-Port 100BASE-FX Ethernet Switching Module (WS-X6224-100FX-MT)

WS-X6224
1 2 3 4 5
24 PORT 100FX
Chapter 2
Figure 2-5.) The module has 48 RJ-45 connectors for use
48 PORT ETHERNET SWITCHING
10/100 BASE-T MODULE
Table 2-3 on page
Figure 2-6.) Ports have MT-RJ optical connectors for
6 7 8 9 10 11 12 13 14
100BASE-FX ports
Table 2-3 on page
Ethernet and Gigabit Ethernet Switching Modules
2-35.
15 16 17 18 19 20 21 22 23
2-35.
PHONE
24
OL-9392-05