Debug Platform Matm - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug platform matm

Use the debug platform matm privileged EXEC command to enable debugging of platform-dependent
MAC address management. Use the no form of this command to disable debugging.
Syntax Description
aging
all
ec-aging
errors
learning
rpc
secure-address
warning
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines
The undebug platform matm command is the same as the no debug platform matm command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
78-16181-03
debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address | warnings}
no debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address |
warnings}
Display MAC address aging debug messages.
Display all platform MAC address management event debug messages.
Display EtherChannel address aging-related debug messages.
Display MAC address management error messages.
Display MAC address management address-learning debug messages.
Display MAC address management remote procedure call (RPC) related debug
messages.
Display MAC address management secure address learning debug messages.
Display MAC address management warning messages.
Modification
This command was introduced.
debug platform matm
Catalyst 3750 Switch Command Reference
B-49