Cisco Catalyst 3750 Command Reference Manual page 392

show interfaces
This is an example of output from the show interfaces switchport backup command:
Switch# show interface switchport backup
Switch Backup Interface Pairs:
This is an example of output from the show interfaces interface-id pruning command:
Switch# show interfaces gigibitethernet1/0/2 pruning
Port
This is an example of output from the show interfaces interface-id trunk command. It displays trunking
information for the port.
Switch# show interfaces gigabitethernet1/0/1 trunk
Port
Gi1/0/1
Port
Gi1/0/1
Port
Gi1/0/1
Port
Gi1/0/1
This is an example of output from the show interfaces transceiver calibration module number
command:
Switch# show interfaces transceiver calibration module 2
C:Celsius, V:volts, mA:milliamperes, mW:milliwatts, RX:receive.
Port
-------
Gi2/0/3
Port
-------
Gi2/0/3
This is an example of output from the show interfaces transceiver properties command. If you do not
specify an interface, the output of the command shows the status on all switch ports:
Switch# show interfaces transceiver properties
Name : Gi1/0/1
Administrative Speed: auto
Operational Speed: auto
Administrative Duplex: auto
Administrative Power Inline: enable
Operational Duplex: auto
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
Name : Gi1/0/2
Administrative Speed: auto
Operational Speed: auto
Administrative Duplex: auto
Administrative Power Inline: enable
Catalyst 3750 Switch Command Reference
2-364
Active Interface Backup Interface
--------------------------------------------------------------
Fa1/0/1 Fa1/0/2
Fa3/0/3 Fa4/0/5
Po1 Po2
Vlans pruned for lack of request by neighbor
Mode Encapsulation
auto negotiate
Vlans allowed on trunk
1-4094
Vlans allowed and active in management domain
1-4
Vlans in spanning tree forwarding state and not pruned
1-4
Temperature
Slope/Offset(C)
------------------- ------------------- --------------------
1.0000/ 0.0000
Transmit Power
Slope/Offset(mW) RX_POWER4/RX_POWER3/RX_POWER2/RX_POWER1/RX_POWER0
-------------------- -------------------------------------------------
Chapter 2 Catalyst 3750 Switch Cisco IOS Commands
State
Active Up/Backup Standby
Active Down/Backup Up
Active Standby/Backup Up
Status Native vlan
trunking 1
Voltage
Slope/Offset(V) Slope/Offset(mA)
1.0000/ 0.0000 1.0000/
Receive Power
Current
0.000
78-16181-03