Yamaha O1V96 Owner's Manual page 213

3 Move the cursor to the PORT parameter box in the MACHINE CONTROL sec-
1
tion ( ), then rotate the Parameter wheel to select the MMC destination.
The following ports and slot are available as the MMC destination.
• MIDI ..............................MIDI port
• USB ................................USB port
• SLOT ..............................Slot with an MY8-mLAN (mLAN card) installed
If USB is selected, move the cursor to the adjacent parameter box (on the right), and select
one of eight ports.
4 Move the cursor to the DEVICE ID parameter box, then rotate the Parameter
wheel to set the 01V96 MMC Device ID to the same ID number as the exter-
nal device.
MMC commands are effective on devices that use the same Device ID. Therefore, the
01V96's MMC Device ID needs to match the ID of the devices you wish to control.
5 To start remote control, press the DISPLAY ACCESS [DIO/SETUP] button
repeatedly until the DIO/Setup | Machine page appears.
2
3
4
This page contains the following parameters:
A
LOCATE/TIME section
This section enables you to set the locate points.
• LOCATE 1–8 .................These buttons locate the positions (specified by the TIME val-
• RTZ ................................This Return To Zero button locates the zero timecode position
• TIME..............................Locate points are specified in hour/minute/second/frame for-
• CAPTURE .....................These buttons capture the current position on external
B
TRACK ARMING section
This section controls the tracks on external machines.
• 1–24 buttons.................These buttons turn external tracks 1–24 on or off, and set or
• ALL CLEAR...................Turning on this button switches all buttons (1–24) simulta-
Machine Control Function
ues) on external machines.
on external machines.
mat.
machines and import the information into the TIME column.
cancel their Record Ready mode.
neously.
213
1
01V96 Version 2—Owner's Manual
17