Step 3. Preparing The Mounting Surface; Step 4. Installing The Conduit Plug; Figure 2-3 Tracing The Camera Base - Honeywell HD4VDIP User Manual

Step 3. Preparing the Mounting Surface

Step 4. Installing the Conduit Plug

Document 800-07091 Rev A
07/10
HD4 EQUIP Series True Day/Night Rugged IP Network Camera User Guide
1. Affix the mounting template (supplied in the camera box) to the mounting surface or
use the back of the camera base, as shown below, to trace the screw holes.
Figure 2-3 Tracing the Camera Base
Note To prevent moisture from entering the housing, position the enclosure with
the side conduit entry pointing down if you are mounting the camera on a wall
or other vertical surface.
2. Pre-drill three holes as indicated on the template, using the recommended hole size
for the screws being used.
3. Drill out the conduit hole, if required (if you are flush-mounting the camera and pulling
the wires through the back entry conduit) (see
page 21).
Note Alternate fasteners (preferably stainless steel) can be used, provided they are
not larger than the screw holes on the mounting template.
Your camera enclosure base comes with a conduit plug pre-installed in the 3/4 inch conduit
entry on the back. To use the back conduit entry, remove the conduit plug and install it in
the side conduit entry after loosening the locking screw (see
locking screw to secure the conduit plug in place.
Step 4. Installing the Conduit
Figure 2-4). Retighten the
Plug,
21