Chapter 3 Setup
This chapter describes the steps for Autoloader setup.
3.1 Removal of Shipment Stabilizer
The Autoloader has a screw that is fastened to its rear side to stabilize the internal Accessor
during shipment.
Before using the Autoloader, be sure to unfasten this screw.
Caution:
Make sure that the shipment stabilizer screw has been unfastened.
If the power is turned on while the screw is still fastened, operation faults may
occur.
If the error message "***CHK*** CODE:[0084]" is displayed, turn off the power and unfasten
this shipment stabilizer screw before turning the power back on.
- 31 -