Inserting An Sd Card And Usb Memory - Hitachi CP-X268A Operating Manual

Setting up

Inserting an SD Card and USB Memory

When using the projector with a wireless LAN please insert the included Wireless
Network Card.
When using a commercial SD Memory card in order to view images insert the SD
Memory card in the same manner.
And when using a commercial USB MEMORY in order to view images insert the
USB MEMORY to the AUX I/O port.
See User's Manual - Network Function for information on using either type of card.
. Make sure the projector's power switch is OFF.
Remove the SD card slot cover.
.
 Lift the cover slightly by the small
indentation in the middle of the front of the
cover using a finger nail or other means.
 Pull the cover forward and remove it
completely from the projector.
3. Insert the SD card.
Slowly insert the SD card completely into
the SD card slot.
Make sure the angled corner of the SD card is
facing the right side (AUX I/O port side) of the
projector while inserting.
4. Replace the SD card slot cover.
Replace the cover by reversing the procedure used when removing the cover.
NOTE • When using the projector with a wired LAN, please remove the
Wireless Network card.
• Select the "REMOVE MEDIA" on MIU menu before SD card or USB memory
is removed.
NOTE • The LED becomes downward in some USB Memory. Remove the
USB Memory after the accessing is completely finished.
IMPORTANT NOTE • To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be installed to provide
a separation distance of at least 0cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
6
(13)
Indentation
AUX I/O Port
SD Card Slot
Angled corner