Table of Contents
Advertisement
-SET UP- FUNCTIONS
Select -SET UP- and -INITIAL SETTINGS- when setting your TV up for
the first time. Use the CURSOR UP / DOWN or a NUMBER from the
remote to highlight the functions desired.
• AIR/CABLE
Select this function to change between regular VHF/UHF broadcasting
(AIR) and cable TV (CATV1 or CATV2)
Press the CURSOR buttons to highlight the correct AIR/CABLE mode and
press MENU to exit.
Reception channels for each mode are shown at the right.
Refer to your cable or TV guide for channel identification standards.
If certain CATV channels are poor or not possible in the CATV1 mode, set
-AIR/CABLE- select to CATV2.
• AUTOPROGRAM
This feature will automatically store active TV channels in CHANNEL
MEMORY. This will allow you to skip over unused channels when using
the CHANNEL UP (
) or DOWN (
) buttons.
If the MENU button is pressed while the autoprogramming function is
engaged, programming will stop.
See CHANNEL MEMORY to add or erase additional channels.
• CHANNEL MEMORY
Use this function after AUTOPROGRAM to add or erase additional
channels to the remote control CHANNEL
,
buttons.
28
Advertisement
Table of Contents
