Attach The Tv And Vcr To The Power Supply; Install Batteries In The Remote Control; Set The Rf Or Video Channel Switch - Hitachi VT-F494A Owner's Manual

Hitachi owner's manual video deck vhs vt-f494a

Table of Contents

Getting Started

provided by this equipment.

5 Attach the TV and VCR to the Power Supply

Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord

or surge protector. See Important Safeguards for further precautions (page 6).

The remote control requires two fresh "AA" batteries. On the back of the remote, a

plastic cover slides off in the direction shown by the arrow. Remove this cover and

install the batteries, matching the plus end of each battery with the plus mark on the

remote.

When the VCR is on, its video signal can come into your TV on either channel 3 or

channel 4. You need to select the appropriate channel.

Turn the power on to both the TV and the VCR, and look for a switch on the back of

the VCR. Set the switch to 3 or 4, whichever is not a commercial channel in your area.

Your basic hookup is now complete. When you're ready to try hooking up a second

VCR or a video camera for a complete home entertainment system, see Advanced

Operations.

Now turn the TV and VCR back around facing you and begin your quick tour of the

controls (page 15).

Table of Contents