Cisco DPC3827 User Manual page 92

Configure Wireless Settings
Select the WDS Settings tab to open the Wireless WDS Settings page. Use this page
to configure the WDS settings.
Wireless WDS Settings Page Description
Use the descriptions and instructions in the following table to configure the wireless
distribution system settings for your residential gateway. After you make your
selections, click Save Settings to apply your changes or Cancel Changes to cancel.
Section
WDS
92
Field Description
WDS MAC Address
Displays the WDS MAC Address (or BSSID) of your gateway
access point.
Allow Wireless Signal To Be Repeated by a Repeater
Check this box to allow a wireless client to connect to a repeater
and route traffic between the wireless client and a repeater. A
maximum of 3 repeaters are allowed.
Remote Access Point's MAC Address (MAC 1 through 3)
Use the three fields (MAC 1, 2, and 3) to enter the MAC address of
the repeaters.
4025083 Rev A