Pppoe Connections - D-Link DSL-500 User Manual

PPPoE Connections

The default connection method used by the Router is Point-to-Point-Protocol over
Ethernet (PPPoE) as defined in RFC 2516. In the PPPoE Configuration window
(shown below) you must to enter the VPI and VCI values, as well as the user
name and password for network account authentication and verification. When
this information is entered, the changes must be saved and the Router restarted.
Follow these steps to establish the PPP and ADSL network connection:
1. Click on the PPPoE Configuration button in the main menu to bring up the
window displayed below:
2. Under PPPoE Login, enter the Login User Name used for the ADSL
account. The user name and login password, are used to authenticate the
identity of the ADSL client and provide access to the service provider's
network. The user name and login password can be any combination of up to
64 characters.
3. Enter the Login Password.
4. Unless you are instructed to use a different Authentication method, leave
the default chap protocol selected. The alternative method, pap, can be
selected from the pull-down menu if required by the network service provider.
5. Change the Connect on Demand option to enabled in the pull-down menu.
6. Leave Idle Time set to the default value 0.
7. Under PVC, enter the VPI and VCI values for the Router.
8. Proceed to the Change User Name and Password and Save Changes sections
in this chapter.
35
PPPoE Configuration
DSL-500 ADSL Router User's Guide