Using Memory (The Remote Control Is Optional For Vm-E110A); Setting The Date And Time - Hitachi VM-E110A Instruction Manual

Getting Started

Using Memory (The remote control is optional for VM-E110A)

The linear time counter memory stops a rewinding tape at approximately 0:00:00M. This
feature helps in locating a specific point in the tape to which you wish to return. An
example might be that you have recorded some tape that you have already watched,
you continue recording but do not care to watch the tape you recorded earlier. The
memory feature returns you to the beginning of the most recent recording.
1. Press the DISPLAY button on the remote control so the linear time counter with
memory is displayed as shown in the figure.
2. Start recording or playback of a cassette. Press the COUNTER RESET button on the
remote control at the point to which you wish to return. The linear time counter clears to
0:00:00M.
3. Press the STOP button to stop playback, or press the start/stop recording and set the
CAM/OFF/VIDEO switch to VIDEO.
4. Press the REW button and the tape stops at approximately where you reset the linear
time counter. This feature works in F.F as well.

Setting the Date and Time

Take the time to set the date and time now. The date and time can be recorded on your
tapes to act as a handy reference when viewing them later. Use the following procedure
to set up the display for the current date and title.
Note: Be sure to insert the date/title battery before setting the date and time. Although the
date and time can be set without the date/title battery inserted, they will disappear when the
battery providing power to the camcorder is removed.
Make sure that the current time is displayed correctly before you start filming.
29