Black & Decker 900143 User Manual page 10

7. Replace silicon plug and drain cap.
8. Remove probe assembly by turning it counter clockwise.
9. Remove plastic baffle from inside reservoir.
10. Clean probe assembly and baffle with a soft cloth using a cleaning mixture of one
gallon tap water and 3 tablespoons unscented household bleach, then rinse and
place on a clean cloth.
11. Pour remaining cleaning mixture into reservoir.
12. Dispense all cleaning mixture through the both taps into a pitcher.
13. Wipe inside of reservoir and area around both taps with a soft cloth. If there is
mineral build-up (white chalky deposits) use a household product designed to
remove calcium, lime or rust. These can be found in grocery and hardware stores.
Follow manufacturer's label instructions.
14. Rinse system by dispensing 1-2 gallons of tap water through both taps into a pitcher.
Make sure all water has been dispensed.
15. Replace baffle and probe assembly.
16. Turn unit around and re-clip Wall Mount Strap to back of dispenser.
17. Clean a fresh water bottle with a soft cloth and warm soapy water, then rinse.
18. Remove tamper seal from top of bottle cap. Do NOT remove plastic cap.
19. Lift bottle and insert onto the probe. Apply slight pressure until the plug inside the
cap pushes in and the bottle is seated.
20. Dispense some water from the COLD tap until air bubbles appear in the bottle.
21. Plug power cord into grounded wall outlet.
22. Flip switch on back of unit to ON.
Model # 900143: Page 10