Tracking Knob; Fuses; Hydro Release Levers - Husqvarna MZ28T Operator's Manual

Tracking Knob

If the mower is not tracking straight, check the
air pressure in both rear tires. Recommended air
pressure is 10 psi. (.7 bar) for the front tires and 15 psi
(1 bar) for the rear tires. Tracking must be checked on
a fl at and level concrete or blacktop surface.
Rotating the tracking knob allows fi ne tuning
adjustments so the machine tracks straight with the
steering control levers in the full forward position.
Rotate the knob clockwise (as viewed from the
operation position) to increase the speed on the left
lever. Rotate counterclockwise to decrease speed.

Fuses

Fuses are located on the left hand side of the
machine. They are accessed by tilting the seat
forward. Fuses are fl at pin fuses type as used in
automobiles.
There are two fuses with ratings and functions:
1. 20 A, Primary fuse
2. 7.5 A, Mower deck coupling

Hydro Release Levers

Transaxle bypass linkages must be engaged when
pushing or pulling the mower. The release levers are
located on each side of the rear of the unit below
the rear engine plate. See Manual Transport in the
Operation section.
CONTROLS
Tracking knob
Fuses
Right side, hydro release lever
8061-010
8050-082
80658-146
21
Husqvarna-