Hour Meter; Tracking Knob; Bypass Linkages - Husqvarna EZ4824 CA Operator's Manual

Table of Contents

Advertisement

Hour Meter

The hour meter displays the total operating time.
It will flash CHG OIL (Change Oil) at 50 hour intervals.
The flash duration is one hour before and one hour
after the interval. The CHG OIL icon will come on
and shut off automatically. The hour meter cannot be
manually reset.

Tracking Knob

If the mower is not tracking straight, check the tire air
pressures. Recommended air pressure is 15 psi (103
kPa / 1 bar) for all tires. Tracking must be checked on
a flat and level concrete or blacktop surface.
Rotating the tracking knob allows fine tuning
adjustments so the machine tracks straight with the
steering control levers in the full forward position.
Rotate the knob clockwise (as viewed from the
operation position) to increase the speed on the left
lever. Rotate counterclockwise to decrease speed.

Bypass Linkages

Transaxle bypass linkages must be engaged when
pushing or pulling the mower. The release levers are
located on each side of the rear of the unit below the
rear engine plate. See Moving Machine By Hand in
the Operation section.
CONTROLS
Hour meter
Tracking knob
Release lever
8052-001
8058-020
8058-147
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ez4824Ez24t966612901966659501966659601

Table of Contents