Declaration Of Conformity - Cisco 4240HDC Manual

FCC Compliance
United States FCC Compliance
This device has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against such interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy. If not installed
and used in accordance with the instructions, it may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment OFF and ON, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna, if applicable.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
diff erent from that to which the receiver is connected.
• Consult the cable company or an experienced radio/
television technician for help.
Any changes or modifi cations not expressly approved
by Cisco Systems, Inc., could void the user's authority
to operate the equipment.
The information shown in the FCC Declaration of
Conformity paragraph below is a requirement of the
FCC and is intended to supply you with information
regarding the FCC approval of this device. The phone
numbers listed are for FCC-related questions only and
not intended for questions regarding the connection
or operation for this device. Please contact your cable
service provider for any questions you may have
regarding the operation or installation of this device.

Declaration of Conformity

This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
1) the device may not cause harmful interference, and
2) the device must accept any interference received,
including interference that may cause undesired
operation.
Explorer 4240HDC and 4250HDC
Digital Interactive Set-top
Models: 4240HDC and 4250HDC
Manufactured by: Cisco Systems, Inc.
5030 Sugarloaf Parkway
Lawrenceville, Georgia 30044 USA
Telephone: 678 277-1120
Canada EMI Regulation
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la class B est conforme à la
norme NMB-003 du Canada.
Software and Firmware Use
The software described in this document is protected
by copyright law and furnished to you under a license
agreement. You may only use or copy this software in
accordance with the terms of your license agreement.
The fi rmware in this equipment is protected by copyright
law. You may only use the fi rmware in the equipment in
which it is provided. Any reproduction or distribution of
this fi rmware, or any portion of it, without our express
written consent is prohibited.
ROVI Corporation Copyright Notice
This product incorporates copyright protection
technology that is protected by U.S. patents and
other intellectual property rights. Use of this copyright
protection technology must be authorized by Rovi
Corporation, and is intended for home and other limited
viewing uses only unless otherwise authorized by Rovi
Corporation. Reverse engineering and disassembly are
prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for
errors or omissions that may appear in this guide.
Cisco reserves the right to change this guide at any
time without notice.
20081121 FCC Standard