Basic Rate Limiting; Advanced Rate Limiting For Access Point Groups - NETGEAR ProSafe WC7520 Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
the specified percentage. The percentage configured for a BSSID is shared among all the
clients connected to it. The total of the percentages distributed among the BSSIDs can be up
to 100%. If a specific BSSID is to be left out of rate limiting, it could be configured to 0%, which
effectively disables rate limiting for that BSSID. A setting of 0% is good for BSSIDs that are
used for management, administration, or testing.
To configure the rate limit:
Select Configuration > Profile > Basic > Rate Limit. The Rate Limit screen displays:
1.
Figure 47.
For each profile on the tab, specify the Rate Limit as a percentage. You can use the slider
2.
bars to adjust the values in the Rate Limit fields.
Click Apply to save your settings.
3.

Advanced Rate Limiting for Access Point Groups

Rate limiting per profile adds up to a maximum of 100%. It can be less than 100%. Tabs are
per radio.

Basic Rate Limiting

Chapter 7: Configuring Wireless Settings | 79