Your Network Connection
Find out how to launch and end your network connection.
Launching Your Network Connection
After the device is plugged in and boots up, a connection to the best available network is
launched automatically.
The device will remain connected at all times, unless:
●
You are out of signal range or the signal is blocked (in a tunnel, etc.).
●
You are in a roaming area and you have chosen not to allow roaming.
Note: Even though the device is connected, you are only billed when data is sent or received.
For more information, see
See also:
●
Internet Connection Information
●
Mobile Broadband Information and Settings
●
Signal Information
Connecting the Device
Connect the device to an available USB port on your computer.
To connect the device to your computer:
1. Insert the device's USB connector into a USB 2.0 or USB 3.0 slot in your computer.
If the computer does not have device drivers installed for the NETGEAR 341U USB Modem,
they are installed using TRU–Install.
Your Network Connection
If the Connection is "Always On," Am I Always Being Billed?
10