Securing Under A Counter; Adjusting The Door Balance - Zanussi ZDM 4714 Instruction Booklet

Securing under a counter

Secure the dishwasher to the counter on the front
part by means of two 3.5 x 16 screws provided
(see fig. - point A).
Important: the dishwasher must be secured
against tilting. Therefore, make sure that the
counter it is fitted under, is suitably secured to
a fixed structure (adjacent kitchen cabinets,
wall).

Adjusting the door balance

After the door panel, the adjustment of the door
balance may be necessary.
The door of the dishwasher is balanced when it is
open in any position.
For this purpose use the two front screws. Open
the door, remove the caps and screw or unscrew
the screws.
In this way the tension of the door balancing
springs is increased or decreased respectively.
Insert the caps again.
The weight of the panel should be within the
limits given in "The furniture door" otherwise
balancing the door will not be possible.
Kitchen plinth adjustment
To allow correct opening of the door it is sometimes
necessary to cut the kitchen plinth. Refer to the
cutting table.
According to dimensions (a) and (b) as shown on
the figure, you will find on the following table the
depth (x) of the cut to be made on the plinth.
The dimensions (a) and (b) of the table are those
most frequently used in the kitchen furnitures.
A
II03
II09
II59
170 160 150 140 130 120 110 100
40 136 131 125 118 110 100 93 85
50
135 131 125 118 110 102 92 85
60
137 132 125 118 110 102 94 85
70
138 134 128 120 110 104 95 85
80 /
139 130 124 115 105 98 88
90 / /
100 / /
(*) dimensions in mm
24
45
a
b
II15
Height (a)*
138 129 120 110 100 90
/
135 125 115 105 95
450 mm
minimum
Dimensions of the
cut on the plinth
X
X
PFI31GB